NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-3787001.png)
SRS Indicator Light: Testing and Inspection
Mode J: Short or Open In SRS Indicator Wire Harness
SRS Indicator Light Stays On Continuously
Mode J: Short or Open In SRS Indicator Wire Harness
Mode J
1. Disconnect the SRS main harness 4P connector from the floor wire harness.
Mode J
2. Measure the voltage between the No. 4 terminal and body ground on the SRS main harness 4P connector side with the ignition switch ON (II).
-
If voltage is more than 8.5 V, go to step 8.
-
If voltage is less than 8.5 V, go to step 3.
3. Before disconnecting any part of the SRS wire harness, install the short connectors (RED).
