NSX-T V6-3.2L DOHC (VTEC) (1997)
Mode J
4. Connect test harness B between the SRS unit and the SRS main harness 18P connector.
5. Reconnect the battery positive cable and negative cable.
Mode J
6. Check for continuity between the B11 terminal and body ground.
-
If there is continuity, the SRS main harness is shorted. Replace the SRS main harness, and recheck the voltages according to the chart.
-
If there is no continuity, go to step 7.
Mode J
7. Check for continuity between the B11 terminal of test harness B and the No. 4 terminal of the SRS main harness 4P connector.
-
If there is continuity, the SRS unit is faulty. Replace it and recheck the voltages according to the chart.
-
If there is no continuity, there is an open in the SRS main harness.