NSX-T V6-3.2L DOHC (VTEC) (1997)
/Page-3260004.png)
2. Check for continuity between the terminals according to the table.
3. If necessary, replace the switch or adjust the switch position.
Starter Solenoid Test
Starter Solenoid Test
1. Check the hold-in coil for continuity between the S terminal and the armature housing (ground). The coil is OK if there is continuity.
2. Check the pull-in coil for continuity between the S and M terminals.
The coil is OK if there is continuity.
Starter Brush Holder Test
Starter Brush Holder Test
1. Check that there is no continuity between the (+) and (-) brush holders.
