NSX V6-3.2L DOHC (2001)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
Hydraulic Assembly
Removal/Installation
NOTE:
-
Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
-
Take care not to damage or deform the brake lines during removal and installation.
-
To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent material.
Removal
1. Pull the lock of the ABS control unit 25P connector up, then disconnect the connector.
2. Disconnect the six brake pipes.
3. Remove the two 6 mm nuts.
4. Remove the ABS modulator-control unit.
Installation