NSX V6-3.2L DOHC (2001)
1. Install the ABS modulator-control unit so aligning the flat section of the mounting bolt and slit of the bracket, then tighten the two 6 mm nuts.
2. Align the connecting surface of the ABS control unit 25P connector.
3. Push the lock of the ABS control unit 25P connector in until you hear the sound, then connect the connector.
4. Bleed the brake system, starting with the front wheels.
5. Start the engine, and check that the ABS indicator goes off.
6. Test-drive the vehicle, and check that the ABS indicator does not come on.