NSX V6-3.2L DOHC (2001)
19. Remove the rubber seal from the adjusting bolt, then remove the middle covers and lower cover.
20. Loosen the adjusting bolt 180° turn. Push the tensioner to remove tension from the timing belt, then retighten the adjusting bolt.
21. Remove the timing belt from the pulleys.
INSTALLATION
Install the timing belt in the reverse order of removal; Only key points are described here.
NOTE: Clean the middle and lower covers before installation.
1. Set the timing belt drive pulley so that the No. 1 piston is at Top Dead Center (TDC). Align the Triangle mark on the teeth side of the timing belt
drive pulley to the Downward pointer on the oil pump.
