NSX V6-3.2L DOHC (2001)
1. Set the double loop band onto the boot with the band end toward the front of the vehicle.
2. Pull up the slack in the band by hand.
3. Make a mark on the band 10 - 14 mm (0.4 - 0.6 inch) from the clip.
4. Thread the free end of the band through the nose section of the commercially available boot band tool (KD-3191 or equivalent), and into the slot
on the winding mandrel.
5. Place a wrench on the winding mandrel of the boot band tool, and tighten the band until the marked spot on the band meets the edge of the clip.