NSX V6-3.2L DOHC (VTEC) (1997)
WARNING: Body parts being dried with an industrial dryer can get hot enough to cause injury. Do not touch parts being dried.
NOTE: Use care when heating to prevent deformation.
5. Sanding filler
-
Sand with double action sander and #180 or #240 sandpaper until the surface is flat and smooth.
WARNING: To prevent eye injury, wear goggles or safety glasses whenever sanding, cutting or grinding.
-
Use a rubber or wooden block back plate when the surface is to be wet or dry sanded by hand,with #280 sandpaper.
-
Wet-sand with #400 - #600 to where primer and primer surfacer are to be applied.
6. Degreasing/Cleaning
-
Clean with wax and grease remover and blow with compressed air.
WARNING:
-
Do not use high air pressure; use only an approved, 210kPa (2.1 kg/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
-
Wipe off all lint and other foreign particles from the surface with a tack cloth.
NOTE: Be sure to use a tack cloth to clean the surface as dust and dirt are electrostatically drawn to the surface.
7. Spraying primer and primer surfacer
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening paint container.
-
Avoid contact with skin,. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store in safe place, and keep it away from sparks, flames or cigarettes.
-
Pour the necessary amount of primer or primer surfacer into a beaker.
-
Add hardener and thinner to the primer or primer surfacer in the correct ratio.
NOTE:
-
Before pouring, stir contents thoroughly.
-
Follow the primer/primer surfacer manufacturer's instructions.
-
Fill the cup with primer/primer surfacer adjust nozzle and pressure, and test spray pattern.
WARNING:
-
Do not use high air pressure; use only an approved, 210kPa (2.1 kg/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
-
Spray primer or primer surfacer as required.