NSX V6-3.2L DOHC (VTEC) (1997)
NOTE: Avoid heavy application of primer/primer surfacer at one time. Allow each coat to flash-off before applying another coat.
8. Drying primer
WARNING: Body parts being dried with an industrial dryer can get hot enough to cause injury. Do not touch parts being dried.
Air dry for 5-10 minutes, then force dry with a infrared dryer.
NOTE:
-
Use constant care when force drying to prevent deformation.
-
Follow the paint manufacturer's instructions.
-
After drying, wet sand the surface with #600 sandpaper and air blow.
WARNING:
-
Do not use high air pressure; use only an approved, 210kPa (2.1 kg/sq.cm, 30 psi) air nozzle.
-
Wear goggles or safety glasses to prevent eye injury.
9. Applying the spot filler
Check the surface and apply spot filler to cavities or flaws in the surface.
NOTE:
-
Apply spot filler evenly.
-
Follow the paint manufacturer's instructions.
10. Drying and sanding spot filler
-
Air dry for 5 minutes, then heat to 140 degrees F (60 degrees C) for 20-30 minutes with a dryer.
WARNING: Body parts being dried with an industrial dryer can get hot enough to cause injury. Do not touch parts being dried.
NOTE: Use care when heating to prevent deformation.
-
After drying, wet sand the surface with #600 sandpaper.
-
Wet-sand with #400 - #600 to where intermediate coating area.
-
Clean, air blow, and degrease thoroughly.
11. Intermediate coat
-
Use top coat enamel base.
WARNING:
-
Ventilate when spraying paint. Most paint contains substances that are harmful if inhaled or swallowed. Read the paint label before
opening paint container.
-
Avoid contact with skin. Wear an approved respirator, gloves, eye protection and appropriate clothing when painting.
-
Paint is flammable. Store in a safe place, and keep it away from sparks, flames or cigarettes.
-
Pour the necessary amount of top coat enamel into a beaker.
-
Add additive and hardener to the paint and mix.
NOTE: Follow the paint manufacturer's instructions.
-
Adjust viscosity with thinner, then pour into cup after filtering.
-
Adjust delivery and pressure, and test spray.
-
Clean the surface with tack cloth and air blow.
-
Spray until the primer or primer surfacer is completely covered.