NSX V6-3.2L DOHC (VTEC) (1997)
Seat Belt Retractor: Service and Repair
SRS wire harnesses are routed near the retractor.
WARNING: All SRS wire harnesses and connectors are colored yellow. Do not use electrical test equipment on these circuits.
CAUTION:
- Be careful not to damage the SRS wire harnesses when servicing the retractor.
- Remove the short connector (RED) from the its holder and disconnect the SRS wire harness connector, then connect the short connector (RED) to the
tensioner connector.
NOTE: To prevent dust, wrap the SRS wire harness connector with a protective cover.
CAUTION: Check the seat belts for damage. and replace them if necessary. Be careful not to damage them during removal and installation.
1. Remove:
-
Seat
-
Center pillar trim panel