NSX V6-3.2L DOHC (VTEC) (1997)
Steering Gear: Testing and Inspection
1. Carefully clamp the gearbox in a vise with soft jaws.
2. Remove the boot bands.
3. Pull the boots away from the ends of the gearbox, then unbend the tie-rod lock washers.
4. Hold the rack with a wrench, and unscrew the tie rods with another wrench.
5. Preload inspection as follows:
a. Slide the steering rack in the cylinder until the end of the rack projects 60 mm (2.4 inches) from the cylinder end. Inspection is made near this
rack position.