NSX V6-3.2L DOHC (VTEC) (1997)
NOTE:
-
Apply glass primer around the entire groove of the new upper and lower moldings.
-
Do not apply glass primer to the outer surface.
7. Run a bead of adhesive in the upper and lower molding grooves.
8. Press the upper and lower moldings into position around the entire edge of the rear window.
NOTE: Check that the upper and lower moldings are not wrinkled or lifted away at the corners.
9. Scrape or wipe the excess adhesive off with a putty knife or towel.
NOTE: Use a soft shop towel dampened with alcohol to remove adhesive from the rear window or upper and lower moldings.