NSX V6-3.2L DOHC (VTEC) (1997)
10. After the adhesive is dry, install the rear defogger sub-harness and ground cable/antenna lead in the upper molding.
11. Set the rear window upright on the body, then center it in the opening. Make alignment marks by marking lines across the rear window and body
with a grease pencil at the four points shown.
12. Glue the upper and lower rubber dams to the inside face of the rear window, as shown, to contain the adhesive during installation.
NOTE: Be careful not to touch the inner glass where adhesive will be applied.