RDX L4-2.3L Turbo (2008)
NOTE:
-
This operation clears the HFL system of all passcode(s), any paired phones, and all names in the HFL phone book.
-
Clearing the HFL system is recommend before selling the vehicle.
1. Press and release the TALK button. After the beep, say "Clear" and the HFL will respond, "This process will clear all paired phones, clear all
entries in the phonebook, and clear the passcode. Is this what you would like to do?".
2. Press and release the TALK button. After the beep, say "Yes" and the HFL will respond, "Preparing to clear all paired phones, all phonebook
entries, and the passcode. This may take up to 2 minutes to complete".
3. Press and release the TALK button. After the beep, say "OK" to proceed, or say "Go back" or "Cancel".
4. If you said "OK", after a short period of time, the HFL will respond, "System has been cleared. Returning to the main menu", the Clearing HFL
system procedure is now complete.
Self-diagnostic Function
NOTE: This procedure should be used only if HDS is unavailable.
To run the self-diagnostic function, do the following:
1. Turn the ignition switch to ACCESSORY (I).
2. Press and hold the HFL BACK button for more than 5 seconds.
3. When the HandsFreeLink system enters the self-diagnostic function, the following will occur.
-
If the system has not completed testing for DTCs, the HandsFreeLink control unit audibly outputs "The hands free system test is in progress".
-
If there is no DTC, the HandsFreeLink control unit audibly outputs "The hands free system is OK".
-
If there is any DTC, the HandsFreeLink control unit audibly outputs "The hands free system needs to be serviced".
NOTE:
-
The self-diagnostic function can only be initiated while the HFL is in its idle state.
-
The self-diagnostic function is considered to start once the 5 seconds press and hold is detected, and ends when the units returns to idle state.
