RDX L4-2.3L Turbo (2008)
15. Remove the bolt securing the outer handle protector. Loosen the mounting nut, and remove the support bar. Remove the protector by releasing the
hook.
16. While pulling the outer handle, remove the handle from the holes in the door panel. Take care not to scratch the door.
17. Remove the rod fastener from the outer handle, then remove the handle.
18. Install the new door outer handle.
19. Reinstall the support bar, and torque the bolt and nut to 9.8 N.m (7.2 lb-ft).
20. Reinstall the spacer, and torque the bolt to 9.8 N.m (7.2 lb-ft).
21. Reinstall the door lock cylinder cable to the latch.
22. Reinstall the center lower channel, and torque the bolt to 8 N.m (5 lb-ft).
