RDX L4-2.3L Turbo (2008)
13. If necessary, remove the special screws, then separate the door lock cylinder (A) and outer handle protector (B). If the retainer (C) is damaged,
release the hooks (D), and replace it.
NOTE: If removed, the special screws must be replaced.
14. Remove the rod fastener (A) from the outer handle (B), then replace it with a new one.
15. Install the handle in the reverse order of removal, and note these items:
-
Make sure the door lock cylinder cable and each rod is connected securely.
-
Make sure the door key cylinder/door locks operate properly.
-
Make sure the door handle works properly.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
Check for water leaks.