RDX L4-2.3L Turbo (2008)
7. While holding the door panel away from the door, remove the inner handle (A) from the door panel by detaching the hooks (B). Remove the door
panel.
8. If necessary, disconnect the inner handle cable (A) and the latch cable (B) from the inner handle (C), then remove the handle.
1. Detach the inner handle cable fastener (D) with a flat-tip screwdriver, then disconnect the inner handle cable from the cable fastener (E).
2. Disconnect the latch cable from the cable fastener (F).
NOTE: Check for damaged or stress-whitened cable fasteners.
9. Install the door panel in the reverse order of removal, and note these items:
-
Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
-
Replace any damaged cable fasteners with new ones.
-
The latch cable (A) should be fixed to the cable fastener (B) with the latch in lock position as shown.
-
Make sure the power window switch connector is plugged in properly, and the cable is connected securely.
-
Make sure the window and power door lock operate properly.
