RDX L4-2.3L Turbo (2008)
Headliner: Service and Repair
Headliner Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Make sure you have the anti-theft codes for the audio and the navigation system (if equipped), then write down the audio presets.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Remove these items:
-
A-pillar trim, both sides.
-
Ceiling light
-
B-pillar lower trim
-
B-pillar upper trim, both sides
-
Quarter pillar trim, both sides
-
Sunvisors, both sides
-
Grab handles, four places
4. Remove the roof console (A).
1. Detach the clip (B) and release the hooks (C) by pulling the map light assembly (D).
2. Disconnect the front individual map light connector (E) and the moonroof switch connector (F), then remove the map light assembly.
3. Remove the bolts (G), and remove the roof console.
