RDX L4-2.3L Turbo (2008)
Scuff Plate: Service and Repair
Trim Removal/Installation - Door Areas
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
Front Door Sill Area
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to bend or scratch the trim and panels.
1. Detach the hooks (A) and tabs (B) from the kick panel (C) and B-pillar lower trim (D), and pull the front door sill trim (E) up by hand to detach
the clips (F, G), then remove it.
2. If necessary, pull the front side outer trim (H) up to detach the clips (I), then remove the trim.