RDX L4-2.3L Turbo (2008)
8. Install the trim in the reverse order of removal, and note these items:
-
Replace any damaged clips (A) with new ones.
-
If the side curtain airbag has deployed, replace the B-pillar upper and lower trim and all clips on the trim with new ones.
-
To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect the trim and replace it if it has any of these
types of damage:
-
Any cracks or deformations in the B-pillar upper trim (B) and the upper hooks (C), and any stress-whitened clips in the upper part of the
trim
-
Any cracks or deformations in the B-pillar lower trim (D), and any breakages in the part (E) fitted with the B-pillar upper trim
-
Any cracks or stress-whitened clips in the seating surface (F)
-
Replace any damaged parts with new ones.
-
Make sure the top of the trim overlaps with the headliner correctly.
-
Make sure the pin (G) on the front seat belt shoulder anchor adjuster (H) and the hole (I) on the back of the slider are engaged when installing
the B-pillar upper trim.
-
Make sure the trim hook is installed into the side curtain airbag B-pillar bracket securely.
-
Push the clip and hooks into place securely.
-
Before installing the anchor bolt, make sure there are no twists or kinks in the seat belt.
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.
Quarter pillar Trim
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend or scratch the trim and panels.
1. Remove these items:
-
Cargo area side trim panel
-
Tailgate weatherstrip, as needed
-
Rear door opening seal, as needed
