RDX L4-2.3L Turbo (2008)
Trim Panel: Service and Repair
Trim Removal/Installation - Rear Side Area
Trim Removal/Installation - Rear Side Area
Special Tools Required
KTC trim tool set SOJATP2014
* Available through the American Honda Tool and Equipment Program.
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend or scratch the trim and panels.
1. Remove these items:
-
Tailgate weatherstrip, as needed
-
Rear door opening seal, as needed
-
Rear door sill trim
-
Rear trim panel
-
Cargo area floor
-
Seat side bolster
-
Cargo area lid
2. Remove the hook (A) of the cover from the pin (B) of the tailgate each side trim, then pull out the cargo area cover (C) to release the lock (D) and
remove the cover.
3. Open the lid (A) and remove the screw (B), then remove the cargo hook (C) (two places).
4. Remove the cargo area side trim panel (A).
1. Using the appropriate trim tool, pry out the lid (B) from the cargo area side trim panel (C) then remove the bolts (D) of the rear side hanger
(E).
2. Remove the clips (F), then remove the trim panel back by hand to detach the clips (G).
3. Pull out the upper edge of the panel back to release the upper hooks (H) from the quarter pillar trim (I).
