RDX L4-2.3L Turbo (2008)
7. Release the parking brake, and remove the brake disc/drum.
8. Remove the hub bearing unit (A).
9. Check the rear hub bearing unit for damage and cracks.
10. Install the hub bearing unit in the reverse order of removal, and note these items:
^
Use a new spindle nut during reassembly.
^
Before installing the spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
^
Before installing the brake disc/drum, clean the mating surface of the hub bearing unit and the inside of the brake disc/drum.
^
Before installing the wheel, clean the mating surface of the brake disc/drum and the inside of the wheel.
^
Check the wheel alignment, and adjust it if necessary.
Knuckle Replacement
1. Remove the hub bearing unit.
2. Remove the parking brake cable (A) from the trailing arm (B).
3. Remove the flange nuts (C), then remove the backing plate (D).
