RDX L4-2.3L Turbo (2008)
NOTE: To prevent damage to the backing plate or parking brake cable, use a short piece of wire to hang the backing plate from the undercarriage.
Do not twist the parking brake cable excessively.
4. Remove the wheel sensor (A) from the knuckle (B). Do not disconnect the wheel sensor connector.
NOTE: Before installation, apply multipurpose grease inside the hole (C) on the knuckle.
5. Remove the lock pin (A) from the upper arm ball joint (B), then loosen the castle nut (C).
NOTE: During installation, install the lock pin after tightening the new castle nut.
6. Disconnect the upper arm ball joint from the knuckle using the ball joint remover, 32 mm.
7. Remove the self-locking nut (B), the washer (C), and the flange bolt (D), then remove lower arm A.
NOTE: During installation, install a new self-locking nut, a new washer, and a new flange bolt.
