RDX L4-2.3L Turbo (2008)
Air Bag: Removal and Replacement
Driver's Airbag Replacement
Driver's Airbag Replacement
Removal
1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel.
3. Using a TORX T30 bit, remove the two TORX bolts (A) and discard them.
4. Disconnect the horn switch connector (1P), then remove the driver's airbag (B).
Installation
1. Connect the horn switch connector (1P) (A) to the driver's airbag.
2. Place the new driver's airbag (B) in the steering wheel, and secure it with new TORX bolts (C).
3. Connect the cable reel 4P connector (A) to the driver's airbag 4P connector, then install the access panel (B) on the steering wheel.
