RDX L4-2.3L Turbo (2008)
Roll Rate Sensor: Service and Repair
Roll Rate Sensor Replacement
Removal
1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Remove the front passenger's seat.
3. Disconnect the SRS wire harness 2P connector (A) from the roll rate sensor.
4. Using a TORX T30 bit, remove the TORX bolt (B), then remove the roll rate sensor (C).
Installation
1. Install the new roll rate sensor with a TORX bolt (A), then connect the SRS wire harness 2P connector (B) to the roll rate sensor (C).
2. Reconnect the negative cable to the battery.
3. Install all removed parts.
4. After installing the roll rate sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about
6 seconds and then go off.