RDX L4-2.3L Turbo (2008)
Seat Occupant Sensor: Service and Repair
Front Passenger's Weight Sensor Replacement
Removal
NOTE: Removal of the front passenger's weight sensors must be done according to Precautions and Procedures.
1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Remove the front passenger's seat assembly section.
3. Remove the cushion cover/pad from the seat cushion frame.
4. Remove the front passenger's seat cushion frame.
5. Using a TORX E18 socket, remove the TORX nuts (A) attaching the seat track (B) to the weight sensors (C).
6. Disconnect the sensor connectors (D) from the seat weight sensor, then remove the front passenger's weight sensors.
Installation
NOTE: Be sure to install the harness wires so they are not pinched or interfering with other parts.
1. Install the new front passenger's weight sensors under the seat track.
2. When tightening the TORX nuts (A), begin with the () and tighten them in crisscross pattern in two or more steps.
