RDX L4-2.3L Turbo (2008)
2. Install the spring (E), and the lower spring cushion (F). Align the bottom of the spring and the lower spring cushion with lower arm B as shown.
3. Position the floor jack at the connecting point of lower arm B and the lower damper mount.
4. Slowly raise the floor jack until you align the bolt hole with the holes in lower arm B and the knuckle, then loosely install the new flange bolt (A).
5. Compress the damper by hand until you align the bolt hole with the holes in lower arm B and the damper, then loosely install the new flange bolt
(C).
6. Connect the stabilizer link to lower arm B.
7. Raise the rear suspension with the floor jack until the vehicle just lifts off the safety stands, then tighten the flange bolts and the self-locking nut to
the specified torque values.
8. Clean the mating surface of the brake disc/drum and the inside of the wheel, then install the rear wheel.
9. Check the rear wheel alignment, and adjust it if necessary.
