RDX L4-2.3L Turbo (2008)
Fluid Line/Hose: Service and Repair
ATF Cooler Hose Replacement
ATF Cooler Hose Replacement
1. Slide the ATF cooler hoses (A) over the ATF cooler lines (B) until the hose ends contact with the bulge (C) of the ATF cooler line, and secure the
hoses with the clip (D) at 2-4 mm (0.1-0.2 inch) (E) from the hose end.
2. Slide the ATF cooler hoses (F) over the ATF cooler lines (G) until the hose ends contact to the white dot (H) on the ATF cooler line, and secure
the hose with the clips (I) at 6-8 mm (0.2-0.3 inch) (J) from the hose end.
3. Secure the ATF cooler hose (K) with the clamp (L) at the white line (M) on the hose.
4. Slide the ATF cooler outlet hose (N) over the ATF cooler outlet line (0) until the hose end contacts with the bulge (P) of the outlet line, and secure
the hose with the clip (Q) at 6-8 mm (0.2-0.3 inch) (R) from the hose end.
5. Slide the ATF cooler hoses (A) over the ATF cooler lines (B) until the hose ends contact with the bulge (C) of the ATF cooler lines, and secure
the hoses with the clips (D) at appropriate points.
