RDX L4-2.3L Turbo (2008)
Fluid Line/Hose: Service and Repair
ATF Cooler Replacement
ATF Cooler Replacement
1. Remove the bumper assembly.
2. Remove the harness clamps, disconnect the ATF cooler hoses from the ATF cooler, and remove the ATF cooler (A) and cooler joint line (B).
3. Remove ATF cooler hoses (A) and mounting brackets (B).
4. Install the mounting bracket on the new ATF cooler (C).
5. Slide the ATF cooler hoses over the ATF cooler lines until the hose ends contact the white dot (D) on the ATF cooler lines, and secure the hose
with the clips (E) at 6-8 mm (0.2-0.3 inch) (F) from the hose end.
6. Secure the ATF cooler hose with the clamp (G) at the white line (H) on the hose.
7. Install the joint line and ATF cooler on the body, and install the harness clamp on the bracket.
8. Connect the ATF cooler hoses to the ATF cooler lines, and secure the hose with the clips.
9. Install the bumper assembly.
