RDX L4-2.3L Turbo (2008)
17. Push the locknut against the transmission housing to seat the transmission range switch into the control shaft, and tighten the locknut (A) to 12 Nm
(1.2 kgf-m, 8.7 ft. lbs.) while holding the control shaft (B) with a 6.0 mm wrench (C), bend the lock tabs (D) of the lock washer against the
locknut.
18. Tighten the bolts (E) to 12 Nm (1.2 kgf-m, 8.7 ft. lbs.) securing the transmission range switch.
19. Install the control lever (A), spring washer (B), lock washer (C), and locknut (D) on the control shaft (E).
20. Apply molybdenum grease to the hole in the bushing in the shift cable end, attach the shift cable end to the control lever, then insert the control pin
