RDX AWD L4-2.3L Turbo (2010)
Trim Panel: Service and Repair
Interior Trim Removal/Installation - Cargo Area
Interior Trim Removal/Installation - Cargo Area
Special Tools Required
-
KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to bend or scratch the trim or the panels.
Rear Trim Panel
1. Remove the cargo area floor.
2. Remove the tailgate weatherstrip, as needed See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Weatherstrip/Service and Repair.
3. Pull up the rear trim panel (A) by hand to detach the clips (B, C, D).
4. Install the panel in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips into place securely.
Cargo Area Floor
1. Remove the cargo area floor (A).