RDX AWD L4-2.3L Turbo (2010)
Timing Chain: Service and Repair
Cam Chain Installation
Cam Chain Installation
Special Tools Required
-
Camshaft Lock Pin Set 07AAB-RWCA120
NOTE:
-
Keep the cam chain away from magnetic fields.
-
Before this procedure, check that the variable valve timing control (VTC) actuator is locked by turning the VTC actuator counterclockwise. If not
locked, turn the VTC actuator clockwise until it stops, then recheck it. If it is still not locked, replace the VTC actuator.
1. Set the crankshaft to top dead center (TDC). Align the TDC mark (A) on the crankshaft sprocket with the pointer (B) on the engine block.
2. Set the camshafts to TDC. The punch mark (A) on the variable valve timing control (VTC) actuator and the punch mark (B) on the exhaust
camshaft sprocket should be at the top. Align the TDC marks (C) on the VTC actuator and exhaust camshaft sprocket.
3. To hold the intake camshaft, insert a camshaft lock pin (A) into the maintenance hole in the camshaft position (CMP) pulse plate A (B) and
through the No. 5 rocker shaft holder (C).