RDX AWD L4-2.3L Turbo (2010)
NO -
Go to step 11.
7. Record all DTCs and sort them into these categories:
-
Battery voltage DTCs
-
Internal error DTCs
-
Loss of communication DTCs (begin with the lowest number first; for example, if B1008 and B1011 are retrieved, troubleshoot B1008 first)
-
Signal error DTCs
8. Troubleshoot the DTCs in this order listed above.
9. Clear the DTCs by pressing and holding the select/reset button for at least 10 seconds.
10. You will hear a beep to confirm the codes have been cleared. Operate the devices that failed, and recheck for codes.
Test Mode 2
11. Remove the MPCS service connector from the under-dash fuse/relay box MICU service check connector socket for 5-10 seconds, then re-insert it
to enter Mode 2. When the system enters Mode 2, the ceiling light will flash two times quickly and then go off.
NOTE: If the MPCS connector is disconnected for too short or too long of a time, or the ignition switch is turned to LOCK (0), the system will return to
Test Mode 1.
12. The following tables list the circuits that can be checked in Test Mode 2. Operate the switch that is most closely related to the problem. If the
circuit is OK, the ceiling light will blink once. If the circuit is faulty, there will be no indication.
MICU
