RDX AWD L4-2.3L Turbo (2010)
Information Bus: Component Tests and General Diagnostics
Troubleshooting - B-CAN System Diagnosis Test Mode D
Multiplex Integrated Control System Troubleshooting - B-CAN System Diagnosis Test Mode D
Perform this diagnosis if a component that is controlled by the B-CAN system does not work or come on.
NOTE:
-
If the component does not turn off or stop, go to B-CAN System Diagnosis Test Mode C See: Troubleshooting - B-CAN System Diagnosis Test
Mode C.
-
See the B-CAN system unit input/output index for a list of input and output devices and the control units that monitor the input and controls the
output devices See: Description and Operation.
1. Check the fuse of the malfunctioning output device.
Is the fuse OK?
YES -
Go to step 2.
NO -
Replace the fuse and recheck.
2. Check for DTCs by selecting the TEST MODE menu from the HDS.
Are any DTCs indicated ?
YES -
Go to B-CAN System Diagnosis Test Mode A See: Troubleshooting - B-CAN System Diagnosis Test Mode A.
NO -
Go to step 3.
3. Turn ON the switch that controls the malfunctioning component.
4. Select DATA LIST from the TEST MODE menu, and check output signal for the malfunctioning component.
Is there an output signal?
YES -
Go to step 5.
NO -
Go to step 9.
5. Test the relay and ground that controls the device that does not work, if applicable. If the relay and ground tests OK, then check for an open or a
short in the circuit for the malfunctioning component.
Are the relay and circuit OK?
YES -
Go to step 6.
NO -
Replace the relay or repair the wire circuit.
