RDX AWD L4-2.3L Turbo (2010)
10. Install the injector clips (D).
11. Coat the new O-rings (green) (E) with clean engine oil, then install the fuel rail and injectors in the injector base (F).
12. Install the fuel rail mounting nuts (G).
13. Connect the connectors on the injectors, and install the harness holder on the fuel rail.
14. Connect the quick-connect fitting.
15. Turn the ignition switch to ON (II), but do not operate the starter. After the fuel pump runs for about 2 seconds, the fuel rail will be pressurized.
Repeat this two or three times, then check for fuel leakage.
16. Reinstall the injector cover, and connect the throttle body 6P connector.
17. Reinstall the charge air cooler See: Turbocharger/Intercooler/Service and Repair.
18. Clear any stored DTCs with the HDS.