RDX AWD L4-2.3L Turbo (2010)
11. Remove the headlight, the front turn signal/front parking light, and the front side marker light from the headlight housing.
12. Remove the igniter harness from the 4P connector in the headlight housing:
NOTE:
To avoid problems during reassembly, note the wire locations in the connector before you remove the wire terminals.
^
On the wire side of the connector, look for a square hole above each wire terminal.
^
Push the special connector tool into the square hole lightly until you feel the resistance increase, then pull out the wire, the terminal, and the
special tool at the same time. Repeat for the other three wires.
13. Tightly wrap the wire terminals and the rubber terminal boot into a bundle with masking tape so it looks like a small egg.
