RDX AWD L4-2.3L Turbo (2010)
Air Bag: Removal and Replacement
Driver's Airbag Replacement
Driver's Airbag Replacement
NOTE: If replacing the driver's airbag after deployment, refer to Component Replacement/Inspection After Deployment See: Service and Repair for a
complete list of other parts that must also be replaced.
Removal
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, then wait at least 3 minutes
before starting work.
2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag inflator 4P connector (B) from the cable reel.
3. Remove the two TORX bolts (A) using a TORX T30 bit.
4. Disconnect the horn switch connector (1P), then remove the driver's airbag (B).
Installation
NOTE: If you are replacing a deployed airbag, inspect the cable reel for heat damage. If there is any damage, replace the cable reel.
1. Connect the horn switch connector (1P) (A) to the driver's airbag.