RDX AWD L4-2.3L Turbo (2010)
11. Install the seat belt in the reverse order of removal, and note these items:
-
Apply medium strength liquid thread lock to the upper anchor bolts before reinstallation.
-
Tighten the bolts by hand first, then tighten to the specified torque.
-
Check that the retractor locking mechanism functions as described See: Testing and Inspection.
-
Assemble the washer, collar and bushing on the upper anchor bolt as shown.
-
If the seat belt tensioner has been deployed, replace the front seat belt protector with a new one.
-
Before installing the anchor bolt, make sure there are no twists or kinks in the seat belt.
-
Make sure the seat belt tensioner connector is properly plugged in.
-
Do the battery terminal reconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures.
-
Check for any DTCs that may have been set during repairs, and clear them.
Front Seat Belt Buckle
1. Do the battery terminal disconnection procedure See: Starting and Charging/Battery/Service and Repair/Procedures, and wait at least 3 minutes
before beginning work.
2. Remove the front seat See: Body and Frame/Seats/Service and Repair/Front Seat Removal/Installation.
3. Lift up the front seat, then disconnect the seat belt buckle switch connector (A) and seat belt buckle tensioner connector (B), detach the harness
clip (C), and release the harness band (D).