RDX AWD L4-2.3L Turbo (2010)
Steering Column Cover: Service and Repair
Steering Column Cover Removal/Installation
SRS components are located in this area. Review the SRS component locations See: Restraint Systems/Air Bag Systems/Locations and the precautions
and procedures See: Air Bag(s) Arming and Disarming/Service and Repair before doing repairs or service.
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Take care not to scratch the dashboard, or the related parts.
1. Adjust the steering column to the full tilt down position, and to the full telescopic out position.
2. Turn the steering wheel to the left and remove the screw (A). Release the hook (B) of the upper column cover (C) while pushing the cover from
the front side.
3. Turn the steering wheel to the right and remove the screw (D). Release the hook (E) of the upper column cover, it is the same as the step 2.
4. Separate the upper column cover from the lower column cover (F) by pulling it up lightly. Release the hooks (G) of the cover to remove it from the
lower column cover.
5. Remove the screws (H, I), then remove the lower column cover from the steering column.
6. Install the covers in the reverse order of removal, and note these items:
-
Push the hooks into place securely.
-
Make sure the wire harnesses are not pinched before tighten the screws.