RDX AWD L4-2.3L Turbo (2010)
6. Disconnect the lower ball joint from the knuckle using the ball joint thread protector and the ball joint remover See: Ball Joint Removal.
7. Install the lower ball joint in the reverse order of removal, and note these items:
-
First install all the components, and lightly tighten the bolts and nuts, then tighten the lower ball joint to the lower arm to the specified torque.
Raise the suspension by loading it with the vehicle's weight before fully tightening the lower ball joint to the knuckle to the specified torque.
-
Torque the castle nut to the lower torque specification, then tighten it only far enough to align the slot with the ball joint pin hole. Do not align
the castle nut by loosening it.
-
Before installing the wheel, clean the mating surface of the brake disc and the inside of the wheel.
-
Check the wheel alignment, and adjust it if necessary See: Alignment/Service and Repair.
