RDX AWD L4-2.3L Turbo (2010)
Control Arm: Service and Repair
Rear Lower Arm A Removal/Installation
Rear Lower Arm A Removal/Installation
1. Raise and support the vehicle See: Wheels and Tires/Vehicle Lifting/Service and Repair.
2. Remove the rear wheel.
3. Position a floor jack at the connecting point of lower arm B and the knuckle.
4. Remove the lower arm A self-locking nut (B), the washer (C), and the flange bolt (D).
NOTE: Use a new flange bolt and a new self-locking nut during reassembly.
5. Remove lower arm A from the vehicle.
6. Install lower arm A in the reverse order of removal, and note these items:
-
Tighten all mounting hardware to the specified torque.