RDX AWD L4-2.3L Turbo (2010)
2. Position a floor jack under lower arm B to support the suspension.
3. Slowly raise the floor jack until you align the bolt hole with the holes in lower arm B and the damper, then loosely install the new flange bolt (A).
4. Raise the rear suspension with the floor jack until the vehicle just lifts off the lift, then tighten the flange bolt to the specified torque.
5. Install the damper mounting cushion (A), the damper mounting washer (B), and a new self-locking nut (C) on the damper shaft.