RDX AWD L4-2.3L Turbo (2010)
Fluid Pressure Sensor/Switch: Service and Repair
4th Clutch Transmission Fluid Pressure Switch Replacement
4th Clutch Transmission Fluid Pressure Switch Replacement
1. Do the battery removal procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
2. Remove the charge air cooler cover See: Powertrain Management/Fuel Delivery and Air Induction/Turbocharger/Intercooler/Service and Repair.
3. Remove the air cleaner See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair.
4. Remove the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Removal.
5. Disconnect the 4th clutch transmission fluid pressure switch connector, and remove the switch (A).
6. Install a new 4th clutch transmission fluid pressure switch and a new sealing washer (B), and tighten the switch.
7. Check the connector for rust, dirt or oil, and clean or repair if necessary, then connect the connector securely.
8. Install the battery base See: Engine, Cooling and Exhaust/Engine/Service and Repair/Engine Installation.
9. Install the air cleaner See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and
Repair.
10. Install the charge air cooler cover See: Powertrain Management/Fuel Delivery and Air Induction/Turbocharger/Intercooler/Service and Repair.
11. Do the battery installation procedure See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.