RDX AWD L4-2.3L Turbo (2010)
5. Pull the knuckle (A) outward, and install the rear drive shaft outboard joint (B) into the rear hub.
NOTE: When installing the outboard joint, support the knuckle. Make sure not to over extend the brake hose.
6. Loosely install a new flange bolt (A) onto lower arm B.
7. Install lower arm A, then loosely install a new flange bolt (B) and a new self-locking nut (C) with the washer (D).
NOTE: Position the "OUT" mark (E) on lower arm A toward the outside of the vehicle.