RDX AWD L4-2.3L Turbo (2010)
7. Apply multipurpose grease to the sliding surfaces of the regulator (A) where shown.
8. Install the glass and the regulator in the reverse order of removal, and note these items:
-
Roll the glass up and down to make sure it moves freely without binding.
-
Make sure that there is no clearance between the glass and the glass run channel when the glass is closed.
-
Adjust the position of the glass as necessary See: Window Glass/Front Door Window Glass/Adjustments.
-
Do the power window control unit resetting procedure See: Power Window Control Module/Testing and Inspection.
-
When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its outside perimeter to seal out water.
-
Check for water leaks See: Window Glass/Front Door Window Glass/Adjustments.
-
Test-drive the vehicle, and check for wind noise and rattles.
-
Make sure the power door lock, the power window, the seat memory, and the power mirror operates properly.
-
Make sure the each connector is plugged in properly.