RL V6-3.5L (2007)
Rear Bumper: Service and Repair
Rear Bumper Removal/Installation
Special Tools Required
-
KTC trim tool set SOJATP2014 *
-
Push pin puller 07AAC-SJAA100
* Available through the American Honda Tool and Equipment Program
NOTE:
-
Have an assistant help you when removing and installing the rear bumper.
-
Take care not to scratch the rear bumper and body.
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
1. Remove the bolts (A), screws (B), and clips (C, D) securing the rear bumper (E).
2. Pull on the rear bumper (A) at the wheel arch areas to release it from the hooks (B) on the side spacers (C).