RL V6-3.5L (2007)
Headliner: Service and Repair
Headliner Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
-
Take care not to bend or scratch the headliner.
-
Be careful not to damage the dashboard and other interior trim.
1. Remove these items:
-
A-pillar trim, both sides
-
Roof console
-
Front individual map light
-
Rear individual map light
-
B-pillar upper trim, both sides
-
C-pillar trim, both sides
2. From both sides, using a trim tool, release the tabs (A), then turn the sunvisor cap (B), and remove it from the bracket (C).
3. From both sides, remove the sunvisor (A) and holder (B).
1. Remove the self-tapping ET screws.
2. Remove the sunvisor from the body and holder.
3. If equipped, disconnect the vanity mirror light connector (C).
4. Using a flat-tip screwdriver, push the hook (D), turn the holder 90 degrees, and then pull it out.