RL V6-3.5L (2007)
* Available through the American Honda Tool and Equipment Program
C-Pillar Trim
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.
NOTE:
-
Follow the C-pillar trim installation procedure carefully; improper installation could cause the side curtain airbags to deploy improperly and
possibly cause injury.
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
The upper clip in the C-pillar trim (A) consists of a resin grommet (B) and a metal pin (C). The groove (D) in the grommet secures it to the body
panel (E). The shoulder (F) on the grommet is broken during removal, so the clip must be replaced with a new one when the trim is reinstalled.
1. Remove these items:
-
Rear seat side cushion
-
Rear seat back
-
Rear door sill trim
-
Rear door opening trim, as needed
2. Release the upper hook (A) from the C-pillar trim (B), then detach the clips by pulling the seat side trim (C) back, then remove it.
3. Hit the upper clip with a rubber mallet. The clip is under the "SIDE CURTAIN AIRBAG" mark (A) near the top of the C-pillar trim (B). Hitting
the clip breaks the shoulder (C) on the grommet (D) and pushes the pin (E) and grommet against the body (F).
