RL V6-3.5L (2007)
8. Clean the caliper thoroughly; remove any rust and check for grooves and cracks.
9. Check the brake disc/drum for damage and cracks.
10. Apply M-77 assembly paste (P/N 08798-9010) to the retainers on their mating surfaces against the caliper bracket indicated by arrows.
11. Install the pad retainers. Wipe excess assembly paste off the retainers. Contaminated brake discs and pads reduce stopping ability. Keep assembly
paste off the discs and pads.
12. Install the pad retainers.
13. Apply M-77 assembly paste (P/N 08798-9010) to the pad side of the shims (A), and back of the brake pads (B) and the other areas indicated by
the arrows. Wipe excess assembly paste off the pad shims and brake pads. Contaminated brake discs or pads reduce stopping ability. Keep
assembly paste off the discs and pads.
14. Install the brake pads and pad shims on the caliper bracket. Install the inner brake pad with its wear indicator (C) facing on top.
If you are reusing the brake pads, always reinstall the brake pads in their original positions to prevent a momentary loss of braking efficiency.
15. Push in the piston (A) so the caliper will fit over the brake pads. Make sure the piston boot is in position to prevent damaging it when installing the
caliper.
NOTE: Be careful when pushing in the caliper, brake fluid might overflow from the master cylinder's reservoir.
