RL V6-3.5L (2007)
4. Turn the ignition switch ON (II).
5. Measure voltage between DLC terminals No. 5 and No. 7.
Is there 8.5 V or more?
YES - Go to step 11.
NO - Go to step 6.
6. Turn the ignition switch OFF.
7. Jump the SCS line with the HDS.
8. Disconnect PCM connector E (31P).
9. Check for continuity between DLC terminal No. 7 and body ground.
Is there continuity?
YES - Repair short to ground in the wire between DLC terminal No. 7 and the PCM (E14). After repairing the wire, check for a DTC with the
HDS and Go to the indicated DTC's troubleshooting.
NO - Go to step 10.
10. Check for continuity between DLC terminal No. 7 and PCM connector terminal E14.
Is there continuity?